Maxon WL7-vers. C Manuale dell'Operatore Scaricare il pdf (Pagina 32)

PATENTS PENDING

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713

HEX

NUT

2 GA

TERMINAL

LUG

FIG. 32-1

4. Cut any excess wire from long power cable.

Strip 1/2” insulation from the cut end and

install 2 GA terminal lug and shrink tubing.

Next, insert the power cable through the

protective cover (FIG. 32-1). Connect the

cable terminal to the terminal stud on the

dc relay as shown in FIG. 32-1. Position the

protective cover over the power cable con-

nection (FIG. 32-1).

5. Route the interlock cable from safety interlock sys-

tem on the vehicle, underneath vehicle ﬂ oor and

through the grommet, and up to the Lift (FIG. 32-2).

If possible, use the same cable routing as the long

power cable installed in previous steps.

Secure the interlock cable every 8”-10”.

6. Make sure interlock cable will reach

the white-red stripe wire (interlock

signal from vehicle) and the brown

wire (interlock signal to vehicle) on

the Lift (FIG. 32-2). Signal may be

ground or V+. Connect the interlock

wires from the vehicle interlock sys-

tem to the white-red stripe wire and

brown wire on the Lift (FIG. 32-2).

FIG. 32-2

INTERLOCK WIRE

(SIGNAL FROM

VEHICLE)

BROWN WIRE

(FROM LIFT)

WHITE-RED STRIPE

WIRE (FROM LIFT)

INTERLOCK

CABLE

INTERLOCK WIRE

(SIGNAL TO

VEHICLE)

ROUTE/CONNECT CABLES & HAND PENDANT - Continued

LONG

POWER

CABLE

EXTERNAL

TOOTH LOCK

WASHER

TERMINAL

STUD

DC RELAY

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 73 74

Commenti su questo manuale

Nessun commento

Maxon WL7-vers. C Manuale dell'Operatore Pagina 32

Commenti su questo manuale